Gridfinity USB & Micro SD Holder

6K downloads · 4 years ago · 1x1 Gridfinity block for storing up to 10 USB devices as well as 3 Micro SD cards. Simple design set

Description

1x1 Gridfinity block for storing up to 10 USB devices as well as 3 Micro SD cards. Simple design set up for fast printing.

Recommended settings are as follows:

Layer Height: .32mm Walls: 3 Infill: 10% - 20% (depending on desire) Supports: No

Drives will sit straight up and down but are intentionally a tiny bit loose - in my experience if they are tight in the socket you end up picking up the whole block instead of the drive you want.

Find all of my Gridfinity models here:

https://thangs.com/search/%22--thingymaker9000gridfinity--%22?scope=all

--thingymaker9000gridfinity--

If you find these or anything else I make useful, you can buy me a beer over here:

https://www.buymeacoffee.com/thingymaker9000

Enjoy!

Community Makes (1)

Community Makes (1)

Discussions

hernangl3 years ago

Hi! printed succesfully! Thanks for your consideration, te holes are not separated enough, can not hold to pendrives togheter.

thingymaker90003 years ago

Hello, thanks for the comment! They may be too small for thicker drives, but they seem to work well for most. If the drives are too thick, you can always leave a blank space between and print another. They are 1x1 so it's configurable. Thanks again!